1991 S-10 Blazer, I have alot of slack in shifter on column, makes it hard to get in gear. how can I change the shifter the best thing to do is put a used colem in. it will save you money in the long ...
...now what. removed the dis cap then try to rotate the belt thuse turning belt see if there is any slack when rotor turns if there is slack or even slight hesitation while turning u need a timing ...
gears when accelerating. Hopefully it's not a transmission problem but the more obvious which would be a universal joint. you have those on each end of the drive shaft and one on each end of the drive
new chain, replace the chain and cam gear as a set, wear on the cam gear will cause the chain to be slack, which in turn causes the cam timing to be late
...steering gear and powerstearing pump and it all helped a lot but it still seems to have excess slack sometimes. It's not all the time but when going down the highway it seems like you have to ...
...that you check out the tie rods, ball joints, pitman arm/control arm, to see if that is where the slack is. Most of the time that is the
The rear axle is making a clunking sound on uneven terrain and the axles have just a little slack when you pull straight out on them. Is this a problem or is it normal wear and tear? therer should be ...
...slack in chain is ok what are the chances of chain breaking? 50/50 If you have gotten as far as that , I would suggest changing the timing chain and gears just to increse performance and fuel ...
Question about 1988 K1500
...a 95 gmc seirra 350 4x4 its got a 97 5 speed it seems to have to much slack in the gears and it still shift fine but how do i tighten it back up what size tires are you running on this..31 33 36
...gears in a chevy s1500 truck? how do I hook up the linkage? Easy to do there is a small bolt Under your dash near the steering cullum slack your bolt put it in park aling your gear red line to park ...
Usually answered in minutes!
4,236 Questions
3,219 Questions
2,541 Questions
2,307 Questions
2,177 Questions