Questions & Answers for: Maxtor sl ch7

hard drive was freezing up .i have already replaced and reloaded now i would like to slave this h.d. to recover my files. i need to reset the jumpers. it is a maxtor n256 model 33073u4 On the back of ...

...luck!! Look here: http://stason.org/TULARC/pc/hard-drives-hdd/maxtor/90510D4-DIAMOND-MAX-5122MB-3-5-SL-ATA4-ULTRA.html try see on botton hard drive label is a jumper settings ...

...jumper settings Look for a 2-by-4 grid of pins. Look closely on the casing, for labels; MA(ster) SL(ave) C(able)S(elect) SP(are) Move the jumper to 'CS', and it should be

...for Maxtor N256 hard drive. Hard drives have three jumper settings on them. 1.MASTER---MA 2.SLAVE---SL 3 CABLE SELECT----CS If you have a hard drive on the end (last) on the ribbon cable ...

...hard drive mod # 510 23HZ Take a VERY close look at the engraving near the jumpers: * MA(ster) * SL(ave) * C(able)S(elect) First, try the 'CS' setting -- your disk-drive might automatically

...and you are putting it on the same cable as the 1st hard drive then the jumper needs to be set as SL (Slave). If you are installing the hard drive on the 2nd disk controller and there is no other ...

Please describe the correct jumper settings for the harddrive in the slave mode. Thanks in advance Right next to power plug are your jumpers referance point is 1 solo pin all the rest are in pairs,on ...

...the printed label gummed onto the top of the disk-drive, for the possible settings: * MA(ster) * SL(ave) * C(able) S(elect) Try the 'CS' position for the jumper, and connect the

how to put the jupers for slave function for hard disk maxtor model 5T010H1 The jumper positions are marked on the circuit board. MA = master SL = slace CS = cable select

i want to identify the sl no. of my hard disk please can u varify the sl no. of my Maxtor IDE 20.4 hard disk below bar code no. is 11S06p5312ZJ1GPVS16L22 is it the sl no. or what or 2B020H1110525 mfg ...