shuttle assembly how should the shuttle and hook look when correctly assembled? I took apart the shuttle but have problem synchronising the needle movement. please help . Have a look at www.sewusa.com
...assembly I took the shuttle apart to clean but have problem aligning/synchronising the needle and shuttle /bobbin movement. I should have taken a picture before I took them apart. What should the ...
...shuttle assembly when you clean and pull out foolow the shuttle race assembly check the position of shuttle foolow this set up as you can see there are two lever lock of shuttle race this your shutle ...
Question about LS-2125 Mechanical Sewing Machine
...shuttle assembly. 1. Raise the needle bar to its highest position and remove the bobbin case. 2. Push levers sideways of the shuttle assembly and liftshuttle and shuttle race cove out by the center ...
...shuttle assembly, cleared the tangled thread and put the assembly back as the manual says. But assembly keeps falling out, as soon as the needle goes into the bobbin it comes loose. I tried a 100 ...
...shuttle frame assembly, disconnect the hammer bank logic and power cables. Power on the printer. If ?HB NOT INSTALLD? appears on the LCD, replace the shuttle frame assembly. If ?HB NOT INSTALLD? does ...
shuttle race assembly. I feel I am putting it in correctly but when i try to stitch it the shuttle becomes loose and the bobbin falls to the floor of the case. I have gone back over the steps and have
Question about P4280, P5005, P5008, P5009, P5010, P5015, P5220S Compat
...shuttle assembly. It could either be the motor in the assembly or the bearings in the shuttle assembly. Put in hold mode. (Press Enable/Hold button)Remove the shuttle cover assembly. (leave the ...
shuttle out, and various other methods and just cannot seem to get the cutter to complete a cut. Any thoughts? You should try replacing the cutter assembly with a new one. They are rather inexpensive
Question about 1996 Grand Cherokee
re-assemble Unimog 404s steeringb ox. 50 loose steel balls do not whant to go inside sliding shuttle .Tnx Two steel ball shuttle feeding loops are at bottom and not accessable. By trying to screw the ...
Usually answered in minutes!
760 Questions
764 Questions
564 Questions
565 Questions
372 Questions