...AC COMPRESSOR CLUTCH FUSE AND RELAY.MAKE SURE POWER IS GOING TO COMPRESSOR CONNECTOR.IF NO CHECK FUSE AND RELAY.IF YES.YOUR PROBLEM COULD BE AC CONTROL SWITCH BAD OR BLOWER MOTOR.COMPRESSOR CLUTCH ...
ac compressor clutch relay on a 1991 honda accord ex Difficult to describe, but I will give it a try. Inside the driver's side fender, close to the front of the car, there is a bracket that is held in
...AC CLUTCH RELAY CIRCUIT MALFUNCTION . POSSIBLE CAUSE.INTERNALLY FUSED IGNITION SWITCH OUTPUT CIRCUIT IS FAULTY. AC RELAY CLUTCH CONTROL CIRCUIT IS OPEN OR IT IS SHORTED TO GROUND. AC RELAY CLUTCH ...
Question about 1998 Durango
...ac clutch disengages but doesnt engage when the ac inside the truck is on. im lost, checked all wires, everythings pluged in and hooked up. The only thing it could be is the conrtol wire of the A/C ...
...replaced. ac compressor clutch coil open or short. wire cut or open to ac clutch.2 wires one is ground the other power, remove connector ac compressor then probe with test light between the two ...
ac relay and new one quickly went bad there are 2, one for front fan and one for the compressor clutch. no matter , but the load that is connected is shorted. eg: fan, shorted fan . eg; clutch shorted
...if present carefully push against outside of clutch with wooden broom handle on downside of rotation.If clutch engages and AC works it's either air gap or high circuit resistance in clutch
Question about 2008 Mdx
I switch around the ac clutch relay with another relay that looks the same then it'll blow cold for a short time. What could be causing the ac relay to trip Bad ac clutch would be the probable culprit
Question about 2008 Mdx
...ac compress short the coils tested from fuse 11, relays, replaced ac relay, ac diode, multi-function relay, test from ac relay to compress, test said replace ac coils, after 3 coils, 1 was ford, 2 ...
Question about 2008 Mdx
...short but where. The electromagnetic clutch inside the belt pulley. Try removing the wire that connects to it behind the Ac compressor pulley and then replace the fuse. If it does not blow the you ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions