Questions & Answers for: sharp microwave blows fuse

Sharp R-9H66C Microwave Convection blowing fuses This unit blew the 20Amp fuse. Rrplaced fuse. Convection runs fine but as soon as microwave is selected and Start pressed. it blows again. Any ...

...Sharp R-1461 Microwave. Makes a loud humming sound and blows fuse behind controll panel. Is it scrap or reasonably fixable? Most likely a shorted capacitor is causing the fuse to blow. Easy and cheap ...

Sharp Model 1451 blown power fuse Power fuse blew and after replacing it I found it blows almost immediately. I turned the turntable off and it still blows almost immediately. 1.Problem with monitor ...

...microwave sharp R8310 blows inside fuse when microwave swiched on If it went dead almost immediately after pressing the Start pad, that's usually a shorted high-voltage capacitor. Here is a link you ...

...Sharp platinum collection 900w microwave oven, model R-957. fuse is marked F8AH 240V and is located on a small circuit board inside the rear of the oven. is this a regular problem or does it indicate ...

...fuse in the system? the light and count down function but no heating. there are fuses in your microwave but they dont normaly blow unless there is another fault, the fuses are not the normal house ...

...sharp mircowave r 520ks The fuse will be a 20amp ceramic. The fuse should be available at hardware stores, Radio Shack. If the fuse is blown, there is a very good chance you have another problem, ...

...microwave - it would seem that some Sharp microwaves use the same flawed design that can cause a blown fuse when the door is opened while the microwave is running - this is an intermittent fault, use ...

...Sharp model # R-5A54 Microwave worked perfectly until it blew a fuse, I replaced the fuse and the display powered on and I reset the time. Then I tried to heat a cup of water and it immediately blew ...

sharp R-352DC Microwave won't heat, and turntable doesn't rotate. Please tell me the problem? Maybe a bad fuse. If the transformer is bad that would blow the fuse. The magnetron unit may be causing it