...set at EX: 1.2.3.4. have someone start the car and point the timming light towards the crank. there should be some marking on it that you will be able to see with the timming light. there should be a ...
no fire wont fire i think i need to set the cams or timing i just tightened the timing belt and now it wont fire I have the same vehicle and had the same problem. It could be one of three things. Yes ...
...located next to the number one injectr It should be a two pronged sensor green at top and should set Codes for it and air temp and mass air flow as well but it is just the engine coolant temp ...
I need the Gap settings What is the Gap setting for the sparkplugs, My engine is the 4 cilinder 1.6 the sparkplugs are shipped with the propper gap setting *DO NOT CHANGE IT" if its been altered, ...
how to set the timing on mazda mx-3 1993 first you need to remove the timing belt cover and locate the timing marks both on the camshaft timing gear and crankshaft pulley and see if the timing mark ...
I have a 1995 Mazda MX-3. It is an automatic 6cyl. with a transmission problem? Reverse acts like neutral, and neutral acts like drive, all other gears operate normally. Is the transmission gone or???
I need troque setting for cylinder head bolts for Madza MX3 Fig. 1: Cylinder head bolt tightening sequence for all 4-cylinder engines 1. Clean the cylinder head bolts and the threads in the block. ...
Question about 1993 MX-3
how to set timing for the mazda mx3 1993 and if timing off canit eat gas runs good but eats gas and no power have you cleaned air filter, checked spark plugs. always look at the small things first, ...
setting timing marks hi i need some help, on a 1995 mazda mx3 1.6 liter dohc im replacing my timing belt and i need to know which timing marks on the 2 cams to use Mr. RAGSDALE. I do not know if you ...
Usually answered in minutes!
138 Questions
122 Questions
88 Questions
72 Questions
6 Questions