...timming to set it is done by crank position sensor check ignition coils if they have rust they will cause missfire.also check plugs and wires with water .if gets worse with water on them and you see ...
Question about 2001 Sunfire
need to know were the timming chain gear is located and how to line up dots to set timming need to know were the timming chain gear is located and how to line up the dots to set timming
need to know where to set the timming marks on my 94 sunbird Should be located on the timing cover and also on the crank. Hope this helps.
there is no heat, only cold air is blowing out. The heat/air only works on setting 4. the switch sound like it needs replaced, the cold air may be your thermostat if not then the heater core. Hope ...
...timming to set on 1998 2.2 4cyl Hello Jm_green. In 1998 the 2.2 Sunfire has no way to set ignition timing. Timing is set by reading crankshaft position (not adjustable) and that signal is sent to the ...
no timming marks on the engine block Thats right. It can't be set!
i set timming car runs like its missing 2001 pont grand am 2.4 twin cam you may want to scan first to get codes.
...timming chain but could it aslo be a vaccum leak What are the actual codes ?Sounds like a problem with the crank and cam sensors.And yes you could have a vac leak but that would not set sensor
Question about 2003 Grand Am
...grand am 3400 v-6 Putting on timming chain need to know where to set the marks. Thank you. This may help you: www.aa1car.com/library/2004/us90410.htm Good luck!! Hope this helps, or check on ...
...the timming cover off to check chain but cant get the crank to move manually to set timming marks Hey Eugene I would recommend taking this to a qualified professional... this sounds serious...
Usually answered in minutes!
1,771 Questions
1,538 Questions
1,504 Questions
1,435 Questions
1,496 Questions