Questions & Answers for: Briggs & Stratton set timming

engine shuts off after about 10 minutes of use engine starts ok, but will shut off after about 10 minutes or so. it will start back up, but will only stay running for 10 or 15 seconds before it shuts ...

I was cutting grass with My Riding Lawn Moore I herd a loud noise and it shut down. When I crank it it spins but no contact or fire. Crank and blades turn but no sounds of starting. It is spinning ...

...timming specks & torgue speck for rod bolts There are no timing "specs", if the flywheel key is good and the magneto air gap is properly set, the timing will be right. Torque for the rod bolts is ...

won't start, backfires I have a INTEK Plus 18.5 hp OHV briggs engine that won't stawas running, now it won't start and backfires when I try to start it. Its your key under flywheel, its sheared or ...

Briggs and Stratton Vanguard 23Hp starter issues I have a Briggs and Stratton Vanguard 23 Hp less than 5 years old with less than 500 hours mounted on an old Simplicity 4041. I've had no problems ...

where is the solenoid for my 2006 yard machine with a 17.5 briggs and stratton motor? This is a riding mower. it is between the seat and steering wheel, remove plate and it is mounted on the front ...

...set timming during assy Valve timing is set by aligning the dots on the cam shaft with the dots on the crank gear, you can als check this by the valves rocking at top dead centre on the non ...

my briggs and stratton 18 hp vanguard model 356447 will not start just back fires through the carb. I have good comprssion and spark at both plugs. I replaced the flywheel key as thought the ...

I have a briggs and stratton 18 hp vanguard mod 356447 that will not start when trying to start it backfires through the carb, It seems to have good spark on both cyclinders using a sprak plug test ...

timming marks /briggs& stratton replacing worn out cam need to no iftimming marks are dot to dot cam to crank set both valves rocking at TDC