Questions & Answers for: GMC Sierra set timing on engine

Ad

Question about 1996 Sierra

1 Answer

...timing mark and the # 1 cylinder is at top dead center ( at the top ). then set the distributor back in the engine wth the rotor pointing to the # 1 cylinder this will bring you very close to where ...

Ad

...set the timing anymore. It sets your camshaft sensor offset, and to need the scanner to read that. If you get it close it will work, but if you have it to far off, the check engine light will be on ...

Ad

Question about 1994 Sierra

2 Answers

...set timing to the desired spec. 6 shut off engine tighten dist. clamp bolt 7 start engine check timing one more time to see if still there at desired setting. 8 shut off engine dis-connect all tools ...

...timing is set correctly. You can locate this particular plug, usually on the firewall in line with the harness. It will simply be a plug that goes to nothing and has a cap in it to close the circuit ...

set timing on 1998 gmc sierra The v-8's timing is supposed to be 0 degrees plus or minus 2 degrees and is only adjustable if you have a scanner. A timing light does not work on them. These engines can

timing be set at? The timing (base), is 0 degrees before tdc. Keep in mind the timing connector must be unplugged. usually a brown wire with a black tracer, has a single connector, located under glove

...timing cover you can unbolt the upper gear the lower one you have to pull. Set the engine up so # 4 cylinder is at the top of the compression stork. install the gears so the mark is down on the upper ...

Question about 1997 Sierra

1 Answer

...Timing should be set by the PCM. So you cant adjust the timing. However if you have a faulty knock sensor the PCM cant tell the proper time to fire. The knock sensor picks up on ignition ping and ...

...timing on the 5.7 liter V8 vortec engine. This system uses the distributor as a camshaft position sensor. You can loosen the distributor and rotate it, but it adjusts something called Camshaft Retard ...

...set timing engine will not hold steady idle. is this normal? NO it should just stop the spark advance .Look at the cam and crank pisition sensors More then likely the crank pisition sensor or your ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

1998 GMC Sierra
1998 GMC Sierra

971 Questions

1997 GMC Sierra
1997 GMC Sierra

824 Questions

2000 GMC Sierra
2000 GMC Sierra

661 Questions

1999 GMC Sierra
1999 GMC Sierra

584 Questions

1994 GMC Sierra
1994 GMC Sierra

587 Questions

Manuals & User Guides

Loading...