Questions & Answers for: Buick LeSabre set timing on engine

...i think its the timin but not to sure on how to replace it Timing chains do not go bad on a 3800. The old 3.8 b engines did. Try a crank sensor. My timing set in my 3800 has 293500.00 miles on

set timing marks when i reinstall timing chain? It depends on the engine. Buy the Haynes manual at your auto parts store or go to the Buick dealer's shop and ask to look at their books for that engine

...timing set. Go to autozone and ask for the camshaft interruptor magnet. About $16.00. Be sure you get the right parts because the used a engine code B 3.8 engine and a code C 3800 engine. The letter ...

...the engine rotation signal when the connector is disconnected. Set the timing to 15 Degrees Before Top Dead Center at idle, then reconnect the four wire connector at the distributor when

...set the timing on a 1995 Buick 3.8L This is a chain and sprocket driven cam on this engine and the timing will be set at 0 degrees when the 2 dots are in line with eachother from the cam gear to the ...

...nearly there stop useing ether it will blow the head of the engine or blow a piston out through the engine take another good look at the timing have you set the module 360% the wrong

...engine electronic controls or the emission control system, every time the fault occurs the light is set, when it clears the light goes off, there is a code set in the computers memory of this fault, ...

...set time periods. Replaced battery, coils, wires,spark plugs. When engine dies engine cranks but not start. After parked awaile engine starts. I would verify a good Crank Position Sensor signal when ...

...set base timing. It can run without the crank sensor once the engine starts. There is a slight chance the timing chain is getting loose and affecting cam timing too. You may be loosing plastic teeth ...

...SET FOR A MONTH STARTED UP AND WAS DROVE OVER 300 MILES THEN THE SAME THING WON'T START ANY MORE HINTS ? How much compression does the engine have ? Jumped time ? These GM engine's had cam gear made ...