...2000-2001 NHTSA CAMPAIGN ID Number: 03V327000 Summary: CERTAIN PASSENGER VEHICLES HAVE HAZARD WARNING SWITCHES THAT MAY EXPERIENCE SOLDER JOINT CRACKING CAUSED BY RAPID TEMPERATURE TRANSITIONS ...
...SET THE FRONT EDGE OF THE GLASS TO BE JUST 1MM BELOW THE SURFACE OF THE ROOF.ADJUST THE GLASS AT THE REAR EDGE TO BE JUST ABOVE 1MM THE ROOF AT THE REAR TIGHTEN THE SCREWS. Here is a GM Bulletin. in ...
...timing cycle • An incorrect password If the BCM does not receive a password within a preset time window, the BCM will enter a short tamper mode. During this mode, the PCM will not allow the car to ...
set it. Aaarrggghh. It's when the security light starts flashing that the infamous "chip" in the key becomes a nightmare to many. Gradually the car begins not cranking anymore or if it cranks it would
...set in the BCM (body control computer). It's when the security light starts flashing that the infamous "chip" in the key becomes a nightmare to many. Gradually the car begins not cranking anymore or ...
...2 separate independently moving compartments for each low and high beam you are stuck with the setup of the low beams. This means you have to adjust the low beams and the high beams are not ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions