Questions & Answers for: Dodge Grand Caravan sequences

speed / tach 'ometers don't work I had lights replaced in the dash panel, specifically the one over the speedometer. Since then, the speedo stops working (pegged all the way around to the stop pin)...

The timing belt just poped on this 3.0.the engine The timing belt just poped on this 3.0. In this 1999 grand caravan ,the engine was burning oil and i figured the guides have droped. So now im pullig ...

light on dash windshild wipers &two other keep blinking sometimes after a while they go off for a litte than go back on YOU HAVE TO TURN THE AIR ON HIGH - FRONT AND BACK AND THEN HOLD DOWN ALL ...

2005 Dodge Grand Caravan. Code check 2005 Dodge Grand Caravan. Engine light on (but not flashing). I have heard there is a way to check the codes without a reader. How do I do this? Cycle the key on, ...

reprogram AC/heater door mode what is the sequence to reprogram AC/heater door mode on 2001 caravan Press and hold the POWER and RECIRCULATE buttons simultaneously for at least 5 seconds. The LEDs on ...

2005 will not start after changing spark plugs and wires, not sure if the wires are in the correct order any ideas? Try this firing order sequence and see if everything is as seen here. Firing Order: ...

lookin for head torque specs and sequence Torque sequence ----------- ' 9 7 3 1 5 ' ' 8 4 2 6 ' ----------- Step 1: torque in sequence to 45 Ft/Lbs Step 2: torque in sequence to 65 Ft/Lbs Step 3: ...

I HAVE A 02 DODGE GC SPORT, WHEN I TURN ON HEAD LIGHTS THEY START TO FLICKER EVERY THING ELSE ELECTRICAL FLASHES IN SEQUENCE RADIO, BLOWER, INSIDE LIGHTS ,WIPERS, JUST RECENTLY THE HEAD LIGHTS WOULD ...

What is the firing sequence for a 1996 Toyota 4runner 3.4 litre 4wd. Also, what is the cylinder number looking from front to back. Hope this helps

CYLINDER HEAD BOLT TORQUE SEQUENCE torque sequence on heads is middle first then stagger to next front then next rear and so on . 50 % of recommended torque on all then final torque all.