Questions & Answers for: separate hayward pump motor

Question about 1.5 Hp Northstar High Performance Pump

1 Answer

Hayward Max-Flo pump: Need to separate pump from motor Motor went bad on my Hayward pool pump... bought a new motor, so how do you get the pump off the motor? Remove the back cover from the motor, ...

Ad

Question about 3/4hp Super Pump Inground Pool Pump 115/230 Volt # Sp2605x7

1 Answer

...separate the motor from the housing? I removed 3 long bolts from the end but now what? Remove the bolts in the back of the plastic strainer housing, that will take the basket assembly off the pump. ...

Ad

Question about 1.5 Hp Northstar High Performance Pump

2 Answers

separate a hayward 2607 pump from the motor and I can't get the pump to to separate. I have downloaded the pump schematic and it doesn't offer a solution. Thanks FROM WHAT I CAN SEE ON MY SCAMATIC THE

Question about 2HP Pool Pump Motor A O Smith Electric Pool Motor for 56J Frame

2 Answers

...pump motor will separate from the pump housing. there are 4 to 6 bolts around the joint between the motor and the pump. You probably want to remove the pump and motor from the system and get it to a ...

Question about Sp2607x10 Super 1 Hp Swimming Pool Pump

1 Answer

separate wet end of pump from motor.If not already off, take diffuser off. Remove back cover of motor and hold center shaft with either a wrench on the flats of the shaft or a large screwdriver on the

Question about 1.5 Hp Northstar High Performance Pump

1 Answer

pump housing. I cannot separate the two assemblies by pulling or carefully prying them apart. I even have the full assembly on my work bench. I do not see of feel any obstructions in the impeller area

Question about 1.5 Hp Northstar High Performance Pump

1 Answer

...Hayward Northstar 1.5 HP pump is pumping water into the pool, but not at full flow rate. This started happening after I cleaned out the filter basket that was plugging off the pump. The cap seems to ...

Question about 1 12 Hp Super Swimming Pool Pump Sp2610x15

1 Answer

...Hayward-SP2610X15-Super-Pump-Parts-Diagram.pdf you can see the seal and the other parts that must be separated in order to replace the seal. THE HARD WAY! Once you are sure the seal is defective you ...

Question about Pool Pump Motor Hayward Swimming Pool Pump Full Rated Motor / Cen

1 Answer

...separate the motor from the pump to access the impeller. Some styles of motors have a screw that is reverse threaded holding the impeller in place, if it has one , remove the screw. Once you have ...

Question about 1.5hp Pool Pump Motor Motor A O Smith Electric Pool Motor for 56j Frame Motors Ust1152

1 Answer

hayward super II you shut off the breaker, remove the rear motor cover, disconnect the electrical wires, then remove the 4 (9/16")bolts holding the motor to the "wet end" which is where the basket is.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Pool & Spa Experts

Jay Finke
Jay Finke

Level 3 Expert

1397 Answers

john h

Level 3 Expert

29492 Answers

David Spradling
David Spradling

Level 3 Expert

13520 Answers

Are you a Pool & Spa Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...