...sensor where is the crankshaft position sensor located on a 1996 Oldsmobile Achieva 2/4L Here you go: Fig. 3: Crankshaft position sensor (1) is located next to the oil filter (2) on the 2.4L ...
...sensor. The oil pressure level sensor is located in the oil pan. Should you need further help please just ask. Please rate this information as it does help in feedback. Thank You for using FixYa. ...
where is the cam sensor locted the camshaft sensor is above the crankshaft pulley.located near the water pump.hope this helps
...This depends on which speed sensor, there are abs speed sensors that are located on each wheel, then a trany speed sensor located on trany,and also trany input and out speed sensors located on
...and only located 1 sensor at the end of the catalytic converter and cant find the front sensor. thanks Geno Facing the engine, look at the back of engine and down. It will be mounted on the
...sensor seen in the image below. However MAF sensors are typically located at the intake manifold and the air intake duct connects to them. Hope this helps. :) It is in the large black tube from the ...
...sensor has the long wire and is located after the catalytic converter. You can purchase a special tool for removing the sensors. If the sensors are positioned so as to allow the use of regular hand ...
...sensor on a 96 olds achieva 2.4? On your 1996 olds achiea the crank sensor is located on the front of the engine , its near the crank pulley,look on the front area on the backside of the
...sensor located on a 1996 oldsmobile acheiva 4 cyl The advice you are seeking is best found at http://www.autozone.com/autozone/repairinfo/componentlocations/componentLocationMain.jsp.. Look up your ...
...only the PCM and the ignition is on this fuse. If you have the V-6, the camshaft and crankshaft sensors are also on it. What I recommend is to disconnect everything on the fuse except the PCM,
Usually answered in minutes!
320 Questions
206 Questions
144 Questions
125 Questions
113 Questions
