Questions & Answers for: Ricoh where is the sensor located

...sensor located? is the td sensor the one located in the centre of the toner revolver? if it is, i have cleaned it but there is no change. if this is not the td sensor, where do i find it? i have ...

...sensor is located under a cover under the transfer unit. i) Open the door ii) Lift out the transfer unit (Q3964A) iii) Locate the black plastic cover plate with a small green flap in the centre. This ...

...of this sensor and how to get to it. Thank you The ID sensor is located under OPC drum.Clean the optics component,the charge corona ,and see if the OPC drum is good(change every 120000

...kopiranje se pojavuva kljuch so functional problems SC350-01.Aparat Ricoh 450. sc 350 is the ID sensor error. clean the ID sensor and it should be fine. the ID sensor is located above the drum

...the message, open and close the top most cover of the printer. Lastly, verify the flags and the sensors. If the problem persists, the cause of the error message could be a broken sensor or sensor ...

what is the meaning of TD SENSOR and where is it located in AF3235?? TS Sensor stands for Toner Density Sensor, it should be located at lower side of the developing unit.

tonner developer sensor td sensor location TD sensor located in the developer unit.

sensor located? I need to clean the sensor to clear the error code. Open right door. Density sensors (5) are located above the transfer belt behind the black plastic cover. Use a damp rag to clean. If

ID SENSOR LOCATION IN SPC 430 DN The ID sensor is usually under the drum unit?

sensor harness disconnected, loose, defective • A drawer connector (located on the rear of a development unit) disconnected, loose, defective • TD sensor defective, replace the PCU Note: The TD sensor