Questions & Answers for: sencor Coffee Makers & Espresso Machines

trouble starting need to know where the crank shaft sencor pigtail on my 94 buick roadmaster is suppose to go to. it got cut off now im having trouble locating where it is suppose to go to behind the ...

...spark this is a 2.3 quad4,car ran fine when i shut it off now it has no spark,ive changed the crank sencor,the coil pack,the ecm modual,the oil pressure sencor,and still no spark,it doesnt have a cam ...

...stopped working then the check engine light come on. The ECU code said it was the vehicle speed sencor.Does this sencor control the odometer also?Is the speed sencor the same as the speedometer ...

The speed sencor in the transmisson needs to be replaced. the sencor says the car is going 90-127 miles an hour then the car stalles. I would like to know if I could unplug one of the wires going into

fan does npt come on when engine is hot If you know the motor is OK then move on to the Temperature sencor one is the coolant temperature sencor and one is simply for the gage or liite ground the wire

mazda 5 sport with light sencors towbar wiring diagram i am trying to fit the witter towbar to my mazda 5 sport with light sencors, can i just connect to the vehicle wiring at the rear of the vehicle ...

...niddle moved all the way to the right of gage and as not moved. Is there a fuse or speed sencor-s to be replace for the repair of the speedometer and what would the fuse name be under to ...

after running with bad o2 sencor for 2 days, starts stalling and idling bad why does my car run badly after new extractors and o2 sencor? Hi i put new extractors in and drove car 2 days with a brocken

I have a 1999 Trans Am with a 5.7 moter. The check engine light was on that said knock sencor 2 was bad. So I replaced both knock sencor. Now when you drive it about 65 or give it a lot of gas the ...

Heat gauge not going up even thou I change the sencor I put new temperature sencor and there is power on the pluk that goes into the sencor but the gauge is not working, it moves a little bit up when ...