washer/dryer The machine does not finish a wash,then the programme selector knob keeps turning,then the on/off indicator constantly flashes. open the filter on the bottom of the machine (water will ...
Question about AWD120 13 lb. Washer / Dryer Combo
ariston margherita wont drain and selector knob keeps turning hi, hoping you can help. my machine stopped on its last wash and did not drain the water. when i try to select a wash the selector knob ...
Question about AWD120 13 lb. Washer / Dryer Combo
hotpoint washing machine WMA32....how can you spin only turn the machine off, turn the selector switch to spin, turn the machine on and press start
Question about Ariston AWD12 Front Load Washer/Dryer
The selector dial is on 4 and will not advance. Has been washing for 5 hours!!! Any clues? because you are a problem of the world........
Question about Ariston AWD12 Front Load Washer/Dryer
My Mum's Ariston AW-12 Washer/ Dryer, Programme selector knob just turns and turns after wash cycle instead of going into a spin. Please help. Regards Ben it sounds like the nob is striped try ...
errore f6 lavatrice ariston wmg 923 wgm 923 F06: Selector Error Overhaul CND (selector connector) Overhaul Selector Connector Control Selector/CND Continuity Control Selector Motor Replace ...
...selected to a desired temp. How can it be fixed and how can i get to either the thermostat knob or selector knob? Gas stove check gas oven safety ...
Question about Ariston AWD12 Front Load Washer/Dryer
Why does the cycle selector not work? The cycle selector (P) does not allow the selection of a cycle and dishwasher door does not lock and will not start. Switch on the door washer will not start ...
Question about Ariston AWD12 Front Load Washer/Dryer
ariston aq9l 29 u Wash cycle selector knob free-wheels? Turn on/off, wait try again. Please note that machine still works, but don't know what cycle, and cannot change cycle. Either the knob or the ...
Question about Ariston AWD12 Front Load Washer/Dryer
The program selector knob keeps turning, what could be the fault? The last time this happened ( about a year ago) the brushes (CBN9191) were worn, so replaced them. Would this be the fault again? ...
Usually answered in minutes!
139 Questions
50 Questions
40 Questions
42 Questions
24 Questions