Question about Radio Controlled Atomic Clock
...second hand doesn't work I recently purchased a London Clock Co radio controlled analogue clock. The second hand moves to 12 when I first insert the batteries. The time then sets itself correctly. ...
Question about Radio Controlled Atomic Clock
...second hand jumps 2 seconds every 2 seconds I inserted new batteries, second hand would not move at all. 1 hour later I came back and clock was running with the correct time. The clock is telling you ...
Question about Radio Controlled Atomic Clock
...where it meets the shaft. Adjust that hand for one minute after the current time. wait about 15 seconds between each hand. Apply the others remembering to set the others to the exact time. let it ...
Question about Radio Controlled Atomic Clock
My Lacrosse radio controlled clock (IECLR6) has begun performing erratically. First it set itself 35 minutes slow. A few days later it began advancing the time rapidly and continually. I removed the ...
second hand ticks in place every second. During this moment the minute hand pauses. Correction -- the second hand will advance 4 seconds while the clock is in a horizontal position. I'd say you have a
Question about Radio Controlled Atomic Clock
second hand will advance eight seconds (2 seconds per step x 4 steps). The clock is now searching for a signal. For the initial setting it is recommended to stand the clock in an upright position near
Question about Radio Controlled Atomic Clock
second hand on our LaCrosse atomic clock has stopped moving but the clock continues to keep perfect time. How do we get the second hand turning again? The manual for one of their clocks says the clock
Second hand has stopped working. Stopped on # 11. Have tried new battery and resetting clock by reinserting battery. Sometimes second hand will work for a limited time. Clock keeps good time with hour
Question about Radio Controlled Atomic Clock
second hand will advance eight seconds (two seconds per step x four steps). The clock is now searching for a signal. For the initial setting it is recommended to stand the clock in an upright position
second hand froze. replaced with another battery, hung, and clock ran a short time, then stopped. took down, laid on back, and clock started to work. when sat up, stopped again. ???????????????/ A bit
Usually answered in minutes!
350 Questions
260 Questions
250 Questions
168 Questions
217 Questions