motor for seat back tilt. I had to remove the seat and take the cables out of the motor and connect the drive cables to 2 drills one in forward and one in reverse. I lubricated the threaded shafts and
...SEAT MOTOR.IF NO REPLACE SWITCH.IF YES REPLACE POWER SEAT MOTOR.FIRST DO A HOT WIRE TEST. ON SEAT MOTOR USING A JUMPER WIRE USING BATTERY TO MAKE SURE YOU DONT HAVE WIRING PROBLEMS. Where would the ...
...motor in the seat transmission, there are three motors, u can't buy just the motor, u must replace the whole unit Most of the time, it is the gears under the seat. I have a video where I go through ...
...seat motor for that. The most common problem is that some of the teeth have broken off of a small gear in the motor. I have a video where I demonstrate one of the many ways to fix this. Here is the ...
motor and seat tries to move but is stuck. How do you free the seat? Did not see any obstructions under seat. The plastic gears in the motor break off a couple teeth. Dealer will try to sell you a new
then test for power and ground at the motor when you push the seat back button, if theres no power or ground then it may be the switch but then you would need to check the same at the switch. good day
Question about 2002 Park Avenue
...motor to the gear box that breaks when there is to much ressitance you can get replacement brass gears on Ebay. Search Buick Park Avenue Seat Motor Gears. Installation instructions are sent with ...
...seat. The motor and cables would need to be removed to allow the seat to move, then there would be nothing to keep the seat in place unless you put the motor back. A manual seat uses a latch and ...
Question about 2005 Rainier
seat motor dies. it tries to push one side, instead of both. Overheats and eventually the heat sink is shot. You are looking at a dealer item. Sorry to say, but the entire seat. I have tried to fix to
Question about 2009 Lucerne
...seat and lumbar adjuster motor is controlled by the MSM through 2 motor control circuits. The MSM connects all motor control circuits on the power rail to a common reference point whenever they are ...
Usually answered in minutes!
1,731 Questions
1,603 Questions
1,084 Questions
1,091 Questions
904 Questions