it in toward the back of the car as well as down at the same time to lock it into those clamps. If you look up near the edge of the area where the seat goes you should see the holes for those brackets
back seat of Olds Alero won't secure to mounts My backseat won't secure to it's mounts...I've tried everything but I can't figure it out. any suggestions? the dealers are asking 100 to look at it. ...
...and install the small end over the pint sleeve (installed on the caliper support) until the boot seats in the pin groove. This is to prevent cutting the pin boot when the sliding body assembly
...is in position, recheck the installation of the pad clips. If necessary, use a small prytool to re-seat or center the pad clips on the support abutments. Install the sleeve bolt and tighten to 20
How do I replace a 93" oldsmobile cutlass fuel pump dose anyone know where i could get a free guide with pics is pos. Removal & Installation Exploded view of the fuel sender, including the fuel ...
...ventilated area. Disconnect the negative battery cable. Relieve the fuel pressure. Remove the rear seat cushion. Remove the floor service hole cover. Disconnect the electrical fuel pump wiring at
...brake fluid. Apply approximately 778 N (175 lbs.) of force to the brake pedal 3 times in order to seat the pads. Burnish the pads and the
change fuel pump,how to pull the back seat out (pull up on the rear bench, look at the front of the bench by the bottom, there is a small bracket (both sides) the goes into a molded space in the floor
...that is broken but may be missing. The brackets on the floor should have a U shaped hook to them, the metal loops on the seat fit into the brackets and the pressure od the seat holds them in
how to remove powered front seat on 1955 Olds 98 undo the 4 bracket bolts
Usually answered in minutes!
1,478 Questions
1,272 Questions
1,097 Questions
1,065 Questions
988 Questions