Questions & Answers for: Homelite seat adjustment

...the carb. setting for a Homelite 45cc chainsaw. Or set up procedure?? Start 1.5 CCW from lighty seated then do as the link suggests. Carburetor Adjustment by Madsens.com ...

...PartsDirect http://www.searspartsdirect.com/partsdirect/index.action Start at 1.5 CCW from lightly seated then tune for performance like this: Carburetor Adjustment by Madsens.com

... Want know who? I would start with both the "H" and "L" needle valves at 1.5 turns CCW from lightly seated then adjust for performance as follows: Carburetor Adjustment by Madsens.com ...

i have a homelite weedeater i need the carb screw settings to adjust the carb A good starting point is from a lightly seated position, back the Hi and Lo needles out about 1.5 turns each. From that ...

adjustment procedure you generally start your low and high mixture screws at one turn from seat, or slowly turn them in all the way until they bottom out and then back them out one full turn. You will

...seat the idle mixture screw and high speed needle adjusting screws. Be sure to write the number of turns down on a piece of paper so you will know how many turns from the seated position to open the ...

...seat the idle mixture screw and high speed needle adjusting screws. Be sure to write the number of turns down on a piece of paper so you will know how many turns from the seated position to open the ...

...adjustment on a homelite chain saw ut 104002 Hi Alex SachsBefore you remove or try to adjust your low and high speed jets you should always count the number of turns it takes to lightly seat the idle ...

...all the way in (clockwise) GENTLY... If you force those screws you will damage the needle valve seats! Turn both screws out one and a quarter turns out, and the saw will start. continue adjusting ...

...and it loads the spark plug up fast. Don't know what's wrong with it. sounds like the needle and seat need to be replaced. the carburetor is flooding out and running in the oil. after you replace ...