...the adjustment 'tang' to drop into one of the large holes in the bar. Make sure the cover is fully seated, then run the fasteners down finger tight. Turn the chain adjuster screw CW until the chain ...
Question about 019t, Ms 190t, 191t Chainsaw Rewind Starter Assembly 1132-080-2800
...adjust your low and high speed jets you should always count the number of turns it takes to lightly seat the idle mixture screw and high speed needle adjusting screws. Be sure to write the number of ...
...adjust your low and high speed jets you should always count the number of turns it takes to lightly seat the idle mixture screw and high speed needle adjusting screws. Be sure to write the number of ...
Question about 026 Ms260 024 Ms240 Original Walbro Wt-194-1 Carburetor
...adjust your low and high speed jets you should always count the number of turns it takes to lightly seat the idle mixture screw and high speed needle adjusting screws. Be sure to write the number of ...
Question about Zama Fs-80 Carburetor C1q-s157 C1q-s63a C1q-s69a Wt-447 C1q-s28d C1q-s45
...adjust your low and high speed jets you should always count the number of turns it takes to lightly seat the idle mixture screw and high speed needle adjusting screws. Be sure to write the number of ...
Question about Zama Fs-80 Carburetor C1q-s157 C1q-s63a C1q-s69a Wt-447 C1q-s28d C1q-s45
...adjust your low and high speed jets you should always count the number of turns it takes to lightly seat the idle mixture screw and high speed needle adjusting screws. Be sure to write the number of ...
Question about Concrete Cutoff Chop Saw Clutch Ts400 Ts 400
...tell you this, the needle will have a rubber tip, if dust has gone through the carb the needle seat may be worn, the needle is replacable unfortunatly the seat is not, the metering lever is also ...
Question about Chainsaw 42mm Piston Rings 025 O25 Chain Saw
i have a stihl 025. the carb i had had 1 adjustment the replacement carb has 2 set screws, what should the settings be to get started with Usually when purchasing a new Carb, they are set very close. ...
saw wont rev up or idle stihl chainsaw 390 will not rev properly or idle properly. l need to know how to set the carberator First thing, try new gas. If that doesn't do it, you need to adjust the low ...
...for older model 028 Both the high an low speed circuits should be at about 1.5 turns out from seated. Gently screw them in until they seat, then turn them back out 1.5 times. This should be ...
Usually answered in minutes!
61 Questions
59 Questions
27 Questions
22 Questions
19 Questions
