my 32000 mac ,IT WILL START BUT THEN IT BOGS OUT.It was sitting for awhile.so I cleaned it up the plug,chain,new gas lines new primer bulb and then it ran long enough for me to cut down agood sized ...
hard to start, and wont idle long. mcculloch d195. how do you adjust carburator? I would start with both the "H" and "L" needle valves at 1.5 turns CCW from lightly seated then adjust for performance ...
WHAT IS THE CARBURATER SETTINGS ON THE 355 MODEL Afternoon George; I would start with both the "H" and "L" needle valves at 1.5 turns CCW from lightly seated then adjust for performance as follows: ...
when running, smells rich, fouls plug, and smokes when running. when adding throddle, cuts out.need to know how many turns on carb screws for low and high mixture adjustments from factory. cleaned ...
set the carb for a mcculloch 3516 chain saw how to set the carb for a mcculloch 3516 chain saw Carburetor Adjustment There are no hard and fast settings. A good initial starting point for the "H" and
i have McCulloch 11-600031D PRO MAC 55 08/73 to 03/77 IPL 92384A-R1. i got it running but it is hard to keep it running i screwed in both idle and mix all the way in i just don't know how much need to
WILL YOU PLEASE TELL ME HOW TO ADJUST THE CARB AIR-GAS THE THREE YOU TURN WITH A SCREWDRIVER Set both the high and low speed screws from lightly seated to 1 1/4 turns out. This will give you a rough ...
...adjust your low and high speed jets you should always count the number of turns it takes to lightly seat the idle mixture screw and high speed needle adjusting screws. Be sure to write the number of ...
Question about Mac 110, 120, 130, 140, 160, Eb Front Casing
...adjust your low and high speed jets you should always count the number of turns it takes to lightly seat the idle mixture screw and high speed needle adjusting screws. Be sure to write the number of ...
Question about Mac 110, 120, 130, 140, 160, Eb Front Casing
...but idles to high. Idle screw adjusted as far as possible, low speed screw turned out 1 turn from seat. By the way it's about 15 years old, could it possibly be a clutch problem and weights worn
Usually answered in minutes!
311 Questions
93 Questions
31 Questions
30 Questions