Questions & Answers for: Proscan screen too loose

...screen static, just one white line several times that pops and hisses really loudly. Then sometimes during this static it turns itself off then right back on. It doesn't matter if I'm watching TV ...

...loose print. loose connector in crt base. crt base loose voltage on screen control or g2 absent or wire loose. screen control located on flyback transformer mistuned. hope this will help good luck.

...screen. Do you think this is an expensive fix? just to be sure, is it vertical or horizontal? Anyway, if it is vertical, it could point out to the vertical Ic section or some loose contacts along the ...

...screen just reads "no signal" and will not play the DVD. First I would run a dvd cleaner in unit! Second you could take tv apart and look to see if signal cable is loose. the power wire seem fine as ...

...does not fill screen width. If change to "zoom" width is full, but loose bottom and top of height of screen. Is there a way to correct this this is normal as you are looking at WIDE screen aspect

...screen are in psychedelic colors and the buttons on the TV itself won't work. Have visually inspected all circuit boards and found no obvious problems and have checked fuse on T-Con board. Is ...

has vertical lines if their is a vertical lines the cause it could be loose connection in the cable going to t-con board which drive signal at the screen panel display. tried to re seat the LVDS cable

...screen. You could have just bumped it on something unknowingly and joggled a connection loose too. If I were you I would consult with the store where you purchased the item and see if they will send ...

...screen picture comes on faintly then fades out .What is causing this problem you may have a loose plug or a bad cap in power supply may need service unless you have tec skills if so check youtube ...

...screen with the Proscan logo(?), you now know your problem is a loose cable connection somewhere. Note: do not tighten the cable connection on the TV with a wrench, pliers, etc. It is too easy to ...