Question about ARMADA M300 11.3" Flat Panel LCD Monitor
screen feels loose/slack when going from a closed position to an open position and vice versa. There is no adjustment on the m300 v300 m700 v700. These hinges will have to be replaced. I do have a set
...screen. if it works, then the problem is most likely a loose cable (connector). It turns out that the connector (which connects the motherboard or gfx card to the LCD screen) on my laptop is torn and ...
...loose from time to time and the screen will go black you have to be carful with this because you may be shorting out the inverter and eventuly you will have no picture it should be and eas fix if the ...
Question about Armada E500 Notebook
compaq armada e5oo laptop...right side of screen looses brightnes after being on for a while, the right side of the screen looses brightness. i have tried adjusting settings in "display" and have ...
Question about Evo N800v Notebook
...loose contact.some times the screen is shaking at the time of booting and immediately hanged.Then system is not working.Some times if we press upon the screen then it will work in good manner.If we ...
...is just when you move it. Hi there. It sounds like you may have a loose inverter cable or the ribbon cable behind the screen is loose. Is the machine in warranty? I please cane your computer RAM ...
compaq c742,screen works fine when partially open,when fully open,screen covered in lines. hey there, This problem occurs due to loosing in wiring of screen and CPU ... You cant overcome from it ...
let go i happens again the screen may be loose or broken. If loose, you'll need to tighten up the screws that hold the screen and the cover together. If the screen is broken, you'll need to replace it
...screen cable went loose at either its connection with the inverter board or the LCD screen itself. You need to disassemble the LCD screen panel & check the cable connections at both ends. I would ...
...loose connection. the best way to know whether it's the screen or the motherboard is to turn it on, wait for about a minute and then press enter. then wait and see if you get the sound of windows ...
Usually answered in minutes!
3,409 Questions
2,234 Questions
1,799 Questions
796 Questions
724 Questions