Question about Perfection 2400 Photo Flatbed Scanner
scanner - that loud sound means your carriage is locked and cannot move - once you set the button to UNLOCK this should solve your problem. My scanner had the same problem. I disconnected the USB from
Question about Perfection 3200 Photo Flatbed Scanner
my epson 3200 photo scanner won't initialize. the power turns on and the scanner tries to move but only moves a little bit. the error light comes on green but beeps 3 or 4 times then goes to red. i ...
Question about Perfection 3200 Photo Flatbed Scanner
...The scanner is not connected to your computer properly or your software is not fully installed. The transportation lock is locked. Slide the lock to the unlock position. try reseting the ...
Question about Perfection 3490 PHOTO Flatbed Scanner
...or your software is not fully installed.The transportation lock is locked. Slide the lock to the unlock position.After trying these solutions, unplug the scanner to turn it off, then plug it back
Question about Perfection 4180 Photo Flatbed Scanner
scanner has racheting noise and red light stays on. No, it's not locked for transport. Harry Watts This noise is caused by the transport lock. Power the scanner off. Lock and unlock the transport lock
Question about Perfection 4870 PRO Flatbed Scanner
THE LOWER SCANNER IS STUCK, AND MAKES GRINDING NOISE SOUNDS LIKE DRIVE GEARS ARE SHEARED OR AVE SOMETHING IN THEM. EPSON 4870 HASN'T BEEN USED ALL THAT MUCH, NEVER HAD ANY OTHER PROBLEMS. CAN'T FIGURE
Question about Perfection 2400 Photo Flatbed Scanner
Perfection 2400 scanner fails to scan; just clicks Perfection 2400 scanner appears stuck - just clicks and sounds like it is trying to move but does not. Start button flashes red. The only thing that ...
Question about Perfection 1660 Photo Flatbed Scanner
Scanner makes a nocking sound when turned on then red flashling light. Does this at powerup. Locate the scanners transport lock. Make sure it is in the unlocked position. Lock it and unlock it a few ...
Question about Stylus CX3200 All-In-One InkJet Printer
my cx3200's control panel reads scanner error. I unlocked the transportation lock, turned off, turned on. It stayed off for about 2 minutes then came right back on. While the error light was off tried
...locked access to the scanner). I hope this helps. Cindy Wells (scanners require two-way communication with the computer and a bad cable will stop the scan even when the computer sees the scanner and ...
Usually answered in minutes!
1,911 Questions
664 Questions
510 Questions
438 Questions
454 Questions