Question about 1998 Expedition
...scan data and create a rich condtion by snping the throttle wide open and watch the sensor if it start to read around 700to 900mv its ok, then create a vacume leak and the sensor should read 100to ...
...scan tool for fault codes. ---------- The air suspension system is designed to improve ride, handling and general vehicle performance for static, on-road and off-road driving conditions: Ride is ...
...scan the veh for codes and look at all the sensor values etc. Including putting an oscilloscope on all sensors. The Throttle Position Sensor is a possible and I could go on. Now,do not throw parts at ...
scan tool willnt tell me any info on this code. What does this code mean? passenger belt and buckle asembly pretensioner circuit resistance out of range. Possible Causes Damaged wiring on Circuit 1081
...Could be a bad Range Sensor Switch, it is on the drivers side of trans about even with case & oil pan Need to look at it with a scan tool or probe it with a meter,not just guess and replace ...
Question about 2000 Expedition
...scan of the system for fault codes as well as a check with a live data scanner tool for engine functions that are not within range of normal, a trained technician is required to know what is correct ...
...scan of the system for fault codes as well as a check with a live data scanner tool for engine functions that are not within range of normal, a trained technician is required to know what is correct ...
...scan tool, the data stream would be the fastest and easiest way to check the sensor circuits. 32 PSI is within normal fuel pressure range [30 to 45 PSI] Check all rubber hoses and connectors for the ...
...scan tool data for the oxygen sensors If the Emission Monitors do not run--that is a key If you have O2 Sensor Codes-you check switching times with an oscilloscope,especially if the front to rear ...
Usually answered in minutes!
2,188 Questions
1,825 Questions
1,627 Questions
1,696 Questions
1,161 Questions