Questions & Answers for: Chevrolet out of scan range

Question about 2002 Impala

2 Answers

scan may say o2 out of range, but that is just what the o2 is reading, it could still be a leaking injector or a missing cyl not burning right, the o2 will read out of range with nothing wrong with it

Ad

Question about 2004 Colorado

1 Answer

...SCAN FOR FAULTY TRANSMISSION RANGE SWITCH OR FAULT IN THE THEFT SECURITY SYSTEM. TRANSMISSION RANGE SWITCH LOCATED ON SIDE OF TRANSMISSION ON THE MANUAL SHAFT AND LEVER WHICH SHIFT CABLE CONNECTS TO ...

Ad

Question about 2001 Tracker

1 Answer

range. I would check the temp sensor data with a scan tool to see what it is reading. If it is lower/higher than it should be than there are a couple of possibilities.1. the coolant temp sensor is bad

...on the rear A/C unit and it moves the actuator to its full range and then won't move? In most cases once you replace the actuator, you have to calibrate it with a scan tool thru the

...each transmission range: P, R, N, D3, D2 and D1. Does each selected transmission range match the Scan Tool TR Sw. display? -- Go to Intermittent Conditions in Engine Controls - 2.2 L Go to Step ...

Question about 2000 Chevrolet Silverado 1500 Base

2 Answers

...range on 2000 chevy silverado 1500 4.3 l v6 Get code 181 from time to time. Cannot find a fuel temp sensor location. 181 is not a valid code, it should look like this "P" and four numbers 0-9 There ...

...Scan Values A/C Request Yes/No No Cruise Engaged Yes/No No TCC Enabled ON/OFF OFF TCC Slip Speed RPM Varies Trans. OSS RPM 0 Trans. Range Invalid/Low/Drive2/Drive3/ Reverse/Park/Neutral Park/Neutral ...

Question about 2006 Silverado

1 Answer

...seconds to allow the HO2S heater current to stabilize. Observe the affected HO2S Heater Current parameter with a scan tool. Is the HO2S Heater Current parameter within the specified range? 0.25-1.375 ...

...Range Switch Logic . Switch input to the PCM is represented on the scan tool as HI and LOW. HI indicates an ignition voltage signal. LOW indicates a zero voltage signal. The four parameters represent ...

...scan tool display. - Transmission range DTCs must not be active. If a transmission range DTC is active, the message "Engine running with transmission DTC present" appears on the scan tool display. ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...