...in the hood. What is the price range to fix the problem? First, get the check engine light issue scanned to see what error code you have. Most auto parts stores will read them for free, but will ...
...scan tool. Place the range selector in each transmission range: P, R, N, D4, D3, D2 and D1. Does each range selected match the scan tool IMS display? -- Go to Powertrain Control Module Replacement in ...
...range-go to a commercial auto parts store and ask them to scan the computer for codes (normally they will do this for free). Get the actual code (ask for the specific code, ie 'P0302", it should ...
...scan tool. Place the range selector in each transmission range: P, R, N, D4, D3, D2 and D1. Does each range selected match the scan tool IMS display? -- Go to Intermittent Conditions in Engine ...
...scan tool indicate that the fuel level parameter is within the specified range? 3%-98% Hope this helps you out ! Fuel Gauge Tech How To Properly Diagnose Faulty Fuel Pump Sending Unit ...
Question about 2005 LeSabre
...scan tool display any DTCs? You could have a air temperature sensors problem ! Air Temperature Sensor Replacement - Upper Right Side ?€¢ Air Temperature Sensor Replacement - Upper Left Side ?€¢ Air ...
Question about 2001 LeSabre Limited
range selected match the Scan Tool IMS display? .Replace the lever assembly-manual shaft detent with internal mode switch. Refer to Transmission Overhaul in the 4T65-E Section of the Transmission Unit
...IMS on the scan tool. Place the range selector in each transmission range: P, R, N, D4, D3, D2 and D1. Does each range selected match the scan tool IMS display? At the dealer we test ,not guess
Question about 2001 LeSabre Limited
...range switch 7-way harness connector while moving connectors and wiring harnesses related to the PNP switch. A change in voltage will indicate the location of the malfunction. Reviewing the Fail ...
Question about 2001 LeSabre Limited
range, test the ground circuit for an open/high resistance. Ignition ON, verify the scan tool Liftgate Release is Inactive. ? If not the specified value, test the signal circuit terminal D for a short
Usually answered in minutes!
1,731 Questions
1,603 Questions
1,084 Questions
1,091 Questions
904 Questions