Questions & Answers for: saturn 1 head bolt torque

Saturn L300 myself. Any information about how to do this would be appreciated as it seems to be a debacle just to get in there. For the L- Series Saturns you first take off the head or very top of the

saturn sl1 DOHC - Tighten all bolts in sequence to 22 ft. lbs. (30 N.m). Then tighten all bolts to 37 ft. lbs. (50 N.m). Repeat sequence, tightening all bolts an additional 1/4 turn (90 degrees). SOHC

...1 6 14| engine | 16 12 8 4 3 7 11 15 | --------------------- Final torque must be reached in 3 equal steps Recheck final torque in sequence Hope helps (remember comment and rated this). 2002 saturn ...

...Saturn L series 2.2 liter along with the allignment marks for the intake and exhaust cams To Install: Install or connect the following: Timing chain drive sprocket to crankshaft Rotate the crank so ...

saturn sohc Hello jakeslonewo, I just did one of these today and the procedure is as follows. If you are using new head bolts (Recommended) install the head and toque the bolts to 48 ft.lps.follow the

...1.9 saturn there are 2 different 1.9 engines, so for future ref, you need the 8th digit of the VIN number. use NEW bolts. torque to 22 ft lbs. then turn 90 degrees, then another 90 degrees. initially ...

saturn sl1 ?? The Head gasket is between the head with the valves and the Block. If you are planning on trying to remove and replace this on your own I seriously recommend you get a Haynes or Chilton&

...saturn sl2 1.9 dohc cylinder head torque specs and sequence Cylinder head bolt tightening procedure: CYLINDER HEAD BOLT TIGHTENING SEQUENCE: INTAKE SIDE 8 4 1 5 9 7 3 2 6 10 EXHAUST SIDE In sequence, ...

...head bolts Hoe do I torque the head on my LW200 2.2 Ist thing, you should replace the bolts with new ones. Tighten main bolts 1 thru 10 to 25 ft pounds. Next, tighten bolts 11 thru 14 to 37 ft

...Saturn l200 Head bolts are typically a Torque Angle to Yield specification, an example 100NM plus 75 to 100 Degrees of angle. You should be able to reuse the bolts, assuming that they have not been ...