Questions & Answers for: sata drive

...sata hard drive as master (Between Data cable & Power supply) there you have four pins from left first pin keep the jumper it is going to be as master & the second sata drive keep it as slave & the ...

...sata drive as a floppy drive I had main sata plugged into sata 1. DVDRW sata was plugged into sata 3. All worked good. Then I plugged two more satas into sata ports 2 and 4; I wanted to clone a drive ...

...sata drive but in standard setup in bios no sata drive is displaying. what can i do. is there any bios setup change. please inform me. thanking you my e-mail id is [email protected] I had the ...

...SATA drive ports on the board & one ATA IDE/PATA port. The 4 main SATA ports are numbered, 1 - 4. Your primary SATA drive must be connected to SATA port 1. Your second SATA drive must be connected to ...

SATA drive with a SATA PCI card (DELL 2400 doesnt accept SATA without card) with all my files on it...How do i format the C drive and then (install) the sata card and drive with out formatting that as

...SATA 2 drive on a SATA (SATA 1?) controller, the hard drive must have a jumper position to restrict it to using SATA (SATA 150), and a jumper must be installed. Some drives have the jumper position ...

...SATA hard drive does not have a Molex power connector. The power connector for the SATA drive looks like this: The power connector plugs into the back of the SATA drive just like the Molex connector ...

...SATA hard drive. The SATA card also has an internal IDE port. When the SATA HDD is connected to the SATA card IDE port - via an IDE-to-SATA adaptor (which I also have) - the SATA HDD works fine. But ...

...HTS543232L9A300 SATA Hard Drive is ata our sata connection, because i dont know what kind of new dik i need to buy sata connection our ata you perches ata to sata connector or sata to ata ...

...drive in sata 0 your second drive in sata 1 your optic drive in sata 2....You system (BIOS) will automatically start at sata 0 then sata 1 and so fourth. hope this helps ya and thank you for using ...