Questions & Answers for: sanyo stk

...STK IC's Do the replacement IC's have SANYO on the face of them? If they do not, this could be your problem. You must use the IC that the manufacturer recommends. All IC's are not alike. Go to MCM ...

...sanyo designed the STK series Chip and even though other brands have the stk number they are cheap imitations. origional sanyo parts will come packaged with the sanyo UPC code on the package. ...

...Sanyo STK-394-160's with still no convergence. I checked all of the 20-ohm 1/10w resistors, values look good. The voltages at the STk's look good. I have no convergence control at all. Any ideas or ...

...and they will last longer due to higher heat tolerance. If you're going to replace the STK's - get the 150's, and MAKE CERTAIN they are authentic sanyo IC's. The generic **** won't last

...sanyo is the focus and screen control box. All stk Convergence ICs for rear projection TVs are made by Sanyo, which was the origional producer of the STK series Convergence IC. You need the ...

...STK 392-110 and after a lot of searching found the cheaper ones last 6 month or so be sure to use Sanyo IC's and replace the resistors with them when the IC's let go they take the resistors out I ...

...and only sell original Sanyo stk``s which is what came in your tv, make sure you check for burnt resistors around those stk`s before installing and powering up your set with the new stk`s, ...

...bad (STK 392-110) Replace with the Sanyo Type STK 392-120. Also check for burned resistors in that same circuit. Check them with an ohm meter to be sure because sometimes they look OK by appearance

Sanyo STK's. I wouldn't recommend buying the cheapest one you can find because it will be a copy and go bad again. If you have STK392-110 or 120 or 150 then the STK392-180 can be used. It has a higher

...a difference with Sanyo and Sanken STK IC convergence chips? Just the name, Sanyo quit making the STK series several years ago Sanken, Toshiba and Mitsubishi all have good versions of the STK