...Samsung Silvercare and it shook violently the first time on spin Make sure the washer is leveled properly and all four feet are resting on the floor. If it is level, try running one cysle without any ...
...We check to see if it is unbalanced and move clothes around, but it still does it. What do we need to do? My new Samsung washer shakes so bad. I'm going to call samsung or take it back to sears
Question about Ultima WD72 Front Load Washer/Dryer
the washer to shake and stop giving you the E4 code. The control board that controls this speed increase must be replaced. samsung p 801 shakes violently put a 40lb bag of cat litter on it. guaranteed
...samsung front load washer & dryer yesterday. We used a level after installation that said both were perfectly level, but the washer violently shakes and moves when it does the spin cycle. Any ...
...Samsung washer WF337 and had three service calls on it for shaking badly in the spin cycle. The last seviceman said he contacted Samsung and it needed anti vibration pads to cure the problem but it ...
...Samsung washer/dryer....on the spin cycle it starts to shake really bad and moves the machine 5 inches or more. did something come off balance installing this? Did you remove the shipping bolts for a ...
how do I stop my washer from shaking alot Try adjusting the feet on the washer.
Question about Platinum Front Load Washer - WF42H5200AP/A2
Samsung front load washer, jerks and makes noise when it first starts spinningthen it smooths out, and works fine. on many machines that is normal, the shaking continues until the load is distributed ...
Question about Platinum Front Load Washer - WF42H5200AP/A2
Samsung washer spins shakes like it's off balance an starts over https://www.youtube.com/watch?v=uKBy-9NEF5A front load washer https://www.youtube.com/watch?v=aqrR5vRQ2V0 https://www.youtube.com/watch
Question about Platinum Front Load Washer - WF42H5200AP/A2
...and moves everywhere on spin cycle? It shakes uncontrollably. It's a Samsung front load washer Too heavy or lumpy wash load is the usual cause if the fixing stays have been removed upon
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions