Questions & Answers for: samsung hln5065w lamp ballast

...lamp it is the ballast itself causing the issue. Samsung is well aware and will replace both the ballast and the lamp (since the lamp can be prematurely aged but the bad ballast). After replacment ...

...lamp it is the ballast itself causing the issue. Samsung is well aware and will replace both the ballast and the lamp (since the lamp can be prematurely aged but the bad ballast). After replacment ...

...Samsung DLP it means your lamp is burnt out or has issues. The manual says replace the lamp when all 3 lights are blinking. If you can hear the arc from the ballast the lamp should light if the lamp ...

Samsung HLN5065W Lamp won't stay on. My set will only stay on for a couple of minutes, then the lamp turns off. If you try to turn it on it cycles on and off with sound only.The lamp will not turn on ...

...Samsung HLN5065W turns itself off after about 15 minutes, and all three lights on the front panel flash. The first couple of times this happened, there was a loud muffled sound before it shut itself ...

samsung hln5065w dlp blows bulbs samsung hln6065w blows dlp bulbs. someone said the board may be bad. what components are known to cause this on this model? The N series, needs to be told via service ...

...Samsung hln5065w dlp tv went blank. When I turned the tv back on after trying to reset it there was a winding noise but no picture. I replaced the lamp and still no picture. The timer-lamp-and temp ...

Samsung HLN5065W will not start up. Goes through 3 cycles and then lights in center circle blink. A new lamp was installed 2 months ago and it worked fine. The first time it didn't start-up, I ...

...samsung HLN5065W dlptv. My wife turned it on one night and no picture. we did get sound. i noticed when I turn the tv on, it shuts down and restarts to no avail. I see a blinking lamp light and after ...

...DO NOT TEST THE POWER GOING FROM BALLAST TO THE LAMP ITSELF (the ignition charge is too much ~15kV) I assume you tried a new original Philips lamp and that you replaced the lamp door cover