Questions & Answers for: no rpm sense

...doesn't produce any power I have a Honda 1000 Generator that won't automatically kick to the highet RPM to produce electricity. If you manually move the throttle to a high rpm with your thumb it will ...

my 1988 ranger 2.9 v6 idles fine cannot get past 2200 rpm It seems that some electronic choke or something senses the rpm once over 2200 rpm it automatically slows it down to 1500 rpm ven if you stab ...

...engine should lower the the rpm. If the Idle Air Control valve is working correctly it should sense the load and maintain the rpm or even increase it a bit.. Also this should be cover under

rpm sense loss After installation, followed installation guide's instructions for manual test. Utility power off. Breakers on Generac panel off. Generator's breaker off. Generator's mode switch set to

...it and used throttle body cleaner to flush it out. Ever sense the truck has had hesitation issues at low speed and low RPM's. Any suggestions? Maybe some gunk got into the idle air passageway

rpm indicator not working Check the gap between the magnet on the wheel and the rpm pickup unit that senses the magnet, The sensor could have been bumped and the gap is too wide.

...to try? * easily mounted at crankshaft to sense RPM; * RPM sensor output signals could be read by MCU (electronics microcontrollers); * simple and not expensive; * where to buy the sensors? ...

...sense the guy put the motor in the rpm gauge just jumps. The motor doesn't follow the rpm guage when its doing it. So basically I just want it to stop dancing around. I replaced the cluster and it ...

...rpm sense wire goes to the ground side of one coil, not the hot side. The red is hot and the green was ground on the Chinese gauge I bought. Do a search on the net under "Wiring Problem with Chinese ...

...RPM SENSE LOSS. WHAT IS THIS AND DO I NEED TO CALL SOME ONE TO FIX. RPM Sense loss means that the generator controller hasn't received a valid signal from the ignition coils for 3 seconds of ...