Questions & Answers for: Honda Civic rotor head

...head screws holding each rotor, remove these( you may need an impact driver with a phillips bit and a hammer) pull off the old rotors and reinstall the new ones after cleaning the rust protection off ...

...head gasket replaced and now it misses at idle.Put a timing light on it, its on time.Would it possibly be spark plug wires?Or cap and rotor also? is the idle set at the correct rpms when idling.also ...

what tools do i need to take rotors off just normal metric tools. the one snag is the screw that hold the rotors on. they are #3 phillps head screws that are usually TIGHT and you may need a impact ...

...and didnt know if when i get to the front rotor, do i need to remove the two philips head screws that are in the rotor to remove the rotor? Yes you need to remove both screws and the caliper

head screws out of the rotor then pull it off. if it seems a bit sticky and wont come off then give it a hit with a dead blow. Try this: Remove the tire. Open the caliper bleed screw and pry/ push the

...rotor is pointed to, and the distributor to where it goes into the head. Unplug the distributor, and remove the ditributor hold down bolts. Install the distributor with the rotor and distributor ...

...whold not start 2000 honda civic got over heat i change head gaskit and timeing belt. everything hooked up wires ,ect. check timing and no.1 up compression strke & rotor on distuber is on no.1 ...

...rotor is pointing, scribe a mark across the base plate of the distributor where it mates to the head so you can replace it, then remove the 3 bolts that hold the distributor in, pull it out and ...

head gasket cannot make this happen. The ignition fired out of sequence, a jumped timing belt will cause the vehicle timing to ****** so a timing belt is not the issue.Your solution and the fix is get

...rotor button. My suggestion is plugs and wires. yours? Did the timing belt break? Are you 100% that it is "in time" correctly? Does it spin over effortlessly? If so,do a compression check,and make ...