Questions & Answers for: Ford F-250 rotor head

Question about 1997 F250 SuperCab

1 Answer

...rotor causing excessive brake dust, loss of gas mileage, and pulls to the left. I opened bleed screw on left and released excess pressure and is fine for a while but slowly builds up again. have ...

Ad

Question about 1998 F250 SuperCab

2 Answers

...head gasket has gone between the two if everything is ok have a look at the distributor cap and rotor yates210456 check your coilpacks the 5.4 has a coil pack for each plug and they are known for ...

Ad

Question about 2002 F250 Super Duty SuperCab

3 Answers

...head "allen" wrenchs......and get the anti squeek stuff...just ask the auto parts place where you'l get your pads from.....other than that, do only 1 side at a time. Do not get greases or oils on the ...

...head bolts.remove the inside snap ring (looks like a piece of thick wire) then you can slide the hub out,be sure to take note of the order they came out.remove the snap ring from the axle.The rest is ...

...at operating temp. choke is operational, put new ignition box ,pick-up coil,wires,plugs,cap,and rotor,fuel pump,and filters checked the jets in carb and flow is accurate,using a 4 barrel ...

Question about 1982 F 250

3 Answers

...not turn the light off,then there is a problem with the brakes,if the abs system is ok.The brake rotors can cause the problem,and the pads also,so check brake out all the way around,adjusting the ...

How do I change the rotors on a 1996 F250 4wd truck? CHANGING BRAKE PADS AND ROTORS Changing the brake pads is pretty easy, after you remove the tire locate the two large bolts on the back side of the

...head locking hub bolts back in and use them to pull the lock out. Next is a large nut that has four indentations in it. There's a special socket 4x4 socket available for around $15 that fits right in ...

Question about 1997 F250 SuperCab

1 Answer

...head capscrews. Remove the lock ring seated in the groove of the front disc brake hub and rotor (1102). Remove the hub body assembly from the front disc brake hub and rotor. If the body is difficult ...

...rotor and secure it with a socket and hex-head bolts.  10 Duplicate the process on the passenger side of the F-250.  11 Close the master cylinder after putting the wheels back on the Ford ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...