Questions & Answers for: Nissan rotor head

...rotor. install the 2 torx bolts, size 40? head I think. You are done. If rotors are scored bad, replace them too. you have two bolts on in side of brake caliper undo the hole claipier should come ...

Ad

Question about 1997 Pickup

2 Answers

...on the front brake pads sense they have been replaced? 2) How deeply grooved are the front brake rotors? 3) does the front brakes make a scratching or a grinding sound when the brakes are applied? ...

Ad

Question about 2003 Pathfinder

1 Answer

...unbolt the rotor from the back. Once you take the wheel off you'll see the hub cover take that off (its either bolted in or a metal cover you need to pry off with a flat head screw driver and

Question about 2003 Pathfinder

1 Answer

head screws, and Caliper using a three arm gear puller, it wouldn't budge. Is there some trick getting the rotor off? Any help in this matter would be greatly appreciated. Mike You'll need to take the

...are free. You basically remove the wheels, remove the 2 caliper bolts, remove the caliper bracket bolts, remove the 1 philips head screw near the lug stud and take the rotor off. Reverse to

Question about 1995 Altima

2 Answers

...rotor and plastic cover on distributor and found oil leaking.just like to know if i pull distributor assembly out to change seal,whats the timing procedure and is tis motor interference motor,if the ...

Question about 1986 Pickup 4WD 1986

1 Answer

...rotor(distributer) , spark plugs, and/or plug wires...its time for a tuneup.. replace those and it should run like new... there is an outside chance it could be a bad head gasket or cracked head but ...

Question about 1985 Pickup

1 Answer

head of the stud. Place the rotor on a firm surface and hit the stud from the side that is broken to drive it out through the back side. Put the new stud in from the back side. Try to turn it to where

...rotor screws for 2006 nissan altima2.5? the disc rotors have 4 screws, i am looking for the size of the screws. are they those small brass looking screws that are mounted to the hub? get an impact ...

...repairable and must be replaced as an assembly except distributor cap and rotor head. NOTE: The rotor screw which secures the distributor rotor head to the distributor shaft must be torqued

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2005 Nissan Altima
2005 Nissan Altima

1,587 Questions

2003 Nissan Altima
2003 Nissan Altima

1,450 Questions

2000 Nissan Maxima
2000 Nissan Maxima

1,309 Questions

1995 Nissan Maxima
1995 Nissan Maxima

1,122 Questions

2002 Nissan Altima
2002 Nissan Altima

1,306 Questions

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...