Questions & Answers for: LG rotor head

...rotor starts, rotates a bit and stops OK. Here is the real solution: the dry sensor itself needs to be clean. There is an excess of clothing fiber deposited over the sensor. When you use "sensor dry" ...

...head with this one! I'd only add this: That "Hubcap" looking thing is actually the outer part of the motor, the part that contains the magnets. so YES you are disassembling the motor! It's either the ...

...motor, thermostat and heater, disconnect earth wires, (**PHOTO**). The drum pulley, which is the ROTOR of the direct drive system has a single bolt to undo. Slacken this bolt a turn or two, DO not ...

...head. I have the LG WM2277Hb. Just recently gave me the LE code. In my case the washer drum would just make a hum sound and looked as if it was trying to spin but wouldn't. I found your solution on ...

...head of the bolt with a hammer a few times. Remove bolt and take off rotor. If needed, try again or use a bit longer bolt. (note, you want to have the bolt in far enough so you do not damage any of ...

...rotor. Remove the bolts holding the motor windings. Remove the electric plug on the sensor and unclip it from the motor winding. Snap new sensor on and reassemble. Usually takes under a half hour. On ...

...head. "You have to order it online. *********************** Solution: You are correct---parts & service is still lacking in some areas, regrettably. ********************** Problem: The dryer has ...

...head screws. Take them out and remove the rear cover. You should now see the rear of the motor, which is mounted to the back of the drum. In the middle is a large bolt which holds the stator cover. ...

...rotor off shaft. Remove phillips head screw(s) holding wire protector and possibly ground wire at bottom of motor area. Remove metric bolts from motor coils and remove coil assemble. Unplug 4 wire ...

...rotor bowl, then loosen the 4 hex. head bolts holding the stator about half way. Pull stator down so you can remove the wiring plug from RPS. Check for corrosion. If no corrosion then remove & ...