Questions & Answers for: Chrysler rotor head

rotor and cap, air filter, fuel filter, oil change, timing belt and a head gasket were just replaced. The car starts and runs but has no power when you put it in gear. is it poss. that the timing belt

...head against the outboard pad and hook against the rear of the caliper. Slowly tighten the screw drive and retract the caliper pistons into their bores and breaking the outboard brake pad from the ...

...head against the outboard pad and hook against the rear of the caliper. Slowly tighten the screw drive and retract the caliper pistons into their bores and breaking the outboard brake pad from the ...

...Rotor was the Ignition Module. The ignition timing of your engine depends on variables, with set values that should not be changed. You don't have any ignition points to set the dwell. Your car's ...

...head screw driver behind to help you wedge the rear rotor off, this may work with the hammer to tap it along. A crow bar may even work if you have the clearance. Remember, when tapping the rotor out, ...

...looking washers that are pushed on to the lug nut studs to hold the rotor in place on the assembly line a pair of side head cutters work well to remove them and discard after removed. Hope this

repair. Good luck to you. abs light is always coming on and breaks have been changed along with the rotors. what can be the issue

I have the calipers off and am trying to replace teh rotor in a town and country but they are really stuck on there. What can I do? I have hit them with a rubber mallet already, but they are not ...

...rotor cap and air filter b/c it was missing really bad. was told i need to replace converter...the plugs were fine. Any ideas? Thanks for choosing FixYa Debra and welcome to FixYa. Chrysler is ...

...rotor removal pop the rubber plug out of the backing plate and use flat head screwdriver to roll star wheel on adjuster to bring parking brake shoes in, then beat rotor with a hammer comes right ...