...rod to unlock the door Self clean on many ovens can be a self destruct mode. Door latch motors, sensor probes and even the electronic controls can be destroyed by this operation. Suggest oven cleaner ...
Question about 40494 / 40495 / 40499 Electric Single Oven
...stoves the lock motor is located in the right rear (looking from the front) with a long rod connected to the lock. remove the motor and unhook the rod from the motor
...Preheat Oven takes over 20 minutes to preheat to 400 degrees. the burner element iside the oven(the rod that glow,s orange) is burned out,even though it glows and the oven is warm,the element is worn ...
Question about CWE4800A Electric Single Oven
maytag electri single oven, not getting hot enough? electric rods not getting not coming on, sometimes only the top rod comes on? replace the lower element. easy fix. TURN OFF POWER. remove two screws
Question about CWE4800A Electric Single Oven
...jammed shut or something. Is there another way to get the door open? You can use a long thin metal rod,like a welding rod to open the door. Bend a "U" shape in one end of the rod. Slide the rod in ...
...way to get your oven going again: Pull your range out so you can see behind it. You will see a rod in the upper center part of the oven. There is a cutout in the metal and you can see the ...
...in the upper left or top center of the upper oven cavity,its will be a silver or copper colored rod about 1/4" by 2" to 6" long this rod senses the oven temp and cycles the heat to the ...
...of your range is a motor (right side?) that controls the locking of the door. The position of the rod may not be right because the motor may be bad. You can disconnect the motor and rod. By
Question about 30464 / 30465 / 30469 Gas Single Oven
Oven SMEG SUK61PX8 Fan motor working but the fan slipped of motor rod. There are no signs of break there is no thread on rod. The only thing I have is the fan blade on which there is the nut and a ...
Oven door won't close, light stays on Take back off and you will find a small motor with a rod that locks the door. Pull Or push the rod to set it in the right position. Check the wires going to the ...
Usually answered in minutes!
1,163 Questions
465 Questions
395 Questions
390 Questions
353 Questions