...the post is merely masking the problem. You can buy replacement bushing and a spring compressor pretty cheap. I would go for the real problem. jetfixr is right on this one. Its the top hinge
right lower hinge trim panel (right next to the door) behind you'll find the 4x4 module. disconnect the 2 plugs for about 30 seconds (module have tendency of locking up) IMPORTANT... look at the plugs
...right spot if not grab the pin and loosen it with a pair of vise grips and ajust up down or in and out if required if it is the hinges loosen the botom and top and slide th hinges eithor way remember ...
...right front fender panel (left a 1-2" gap) between the door hinge (the same noise happened when I tried to close it). Since then, I have not opened the door for fear more damage will be done. What ...
...right hinge. To install: Install the gate to the vehicle by lowering the right hinge assembly into position first, then holding the gate at a 45 degree angle and seating the left hinge assembly. ...
...Right hinge pillar trim panel. Electrical connectors from ECM, as necessary. Electrical connectors from blower motor, as necessary. Bolt from right lower I/P support. Blower motor cover. Blower motor ...
hinge. and you need to make sure that it is seated all the way.make sure its the right size bushing or it will turn and come out. also when you install the pins make sure they have the retaining clips
hinge pillar panel and the drivers side door sill panel The windshield metal post from the roof to the bottomof the door sill is called an A -pillarThat is what your door hinges are bolted toThe metal
Question about 2003 Yukon XL
...bal. left and right. I would try a different speaker just in case your went out. Now if it did not go out then it could be the plug in the back of the radio or the wiring broke in the hinge of the ...
Usually answered in minutes!
2,225 Questions
1,363 Questions
1,368 Questions
1,418 Questions
1,123 Questions