Questions & Answers for: Isuzu Trooper reverse wire

Reverse light short My turn signals went out in my 1990 Isuzu Trooper. Found a blown fuse that also is for the reverse lights. I replaced the fuse and found that when I put the truck in reverse the ...

...turn the starter 180 degrees and remove it backwards. When you re-install the starter, do it in reverse order the way it came out. Once the starter is in position then turn 180 degrees around to ...

wire bullet connectors, another detent switch which is reverse lights that also has bullet connectors. put blue to blue and red to red if not car will not turn off with ignition key.these are on upper

is usually for earth wire. The fitter may have just used another white wire for reverse light. use a test light or multimeter to see if you have positive power to the extra white wire while in reverse

location of reverse light switch on gearbox on top section of gearbox near shifter the one closest to the rear of vehicle and it should have 2 red wires(one has trace colour) the blue/red switch is ...

reverse lights. If on the switch is faulty and needs to be replaced. If not measure the voltage across each of the wires and a good earth point. (Gearbox casing will do fine. ) One of the wires should

then removing the retaining bolts from the starter followed by removing the wires from the starter. Reverse the process to put the new starter on

...turn the starter 180 degrees and remove it backwards. When you re-install the starter, do it in reverse order the way it came out. Once the starter is in position then turn 180 degrees around to ...

My 1993 Trooper's reverse lights don't work. I've checked all the fuses and changed the bulbs out but this was fruitless. Please help. I had the same Problem with my 1994 Trooper. I was ...

...reverse. and this is 12vdc then the problem is to the rear. (simple no?) it just a wire. nothing magic here. it goes to both lamps. (white) if the car is A/t did you wiggle the shifter in R to see if ...