Questions & Answers for: Isuzu Rodeo reverse wire

...reverse the wiring on the gear box is connected to switches wrong, there bullet head connectors red to red wiring and blue to blue from switch to loom is correct both wires on one switch are red ...

...wire a relay??....& if so why?? thanks joe. More than likely you will need to use a relay. Your reverse lights are rated for a particular amperage. The wiring, fuse and components are engineered ...

...wire across the terminals to confirm if the switch is out and the rest of the wiring is OK. If the lights then work replace the switch. To remove switch, disconnect wiring, loosen locknut and unscrew ...

...reverse lighs dont work need a wire diagram for this 1997 izuzu rdeo 4x4 Reverse light are operated by the range selector switch on the side of transmission aka. gear selector lever. A problem with ...

...solenoid, loosen and remove 2x 14mm nuts/bolts from starter and remove starter. Replacement is reverse of removal ensuring battery is still ...

...reverse light wire in dash need to find the switchable reverse light wire under the dash to connect reverse camera ?? it would be easier to run it from the back up wire in the rear you can see it ...

wire on the battery before you start the job. Installation is in reverse order as taking it off. you have to remove front exhaust pipe and heatshield,remove oxygen sensor connectors. You don't have to

want to know where to conect blue and black wire on isuzu dmax gearboks want to know where to connect blue and black wire on isuzu dmax 4x4 gearboks If there only two wires then check the blue one for

...stays on module reset sometimes after using four wheel drive the light stays on you can put in reverse and it usually goes out if not the sensor maybe bad its located on the front axel mine had

...be able to see it bolted on to the bell housing. remove the main power wire then the other smaller wire to the solenoid . then remove and replace the starter in the reverse process all should be ...