2005 Pathfinder no reverse lights 2005 Pathfinder LE (automatic) reverse lights do not work. Fuses are all okay. Light bulbs are okay. Brake lights work fine. However, there is no power to the reverse
wire should have power and the other leads to the reverse lights. you can test the switch itself with a ohm meter, or continuity tester aswell if you have one. if you need more help i am here for you.
...a reverse-alarm on my 04 nissan frontier truck which needs to tap into the reverse-lights wire. What color is it? Just check the wires that go into the clear light, inside the tail light
reverse light wire under the dash need to find where I can connect the revere light wire on my Kenwood receiver so I can trigger it to display camera input from rear camera when I put the car in ...
...the revers switch that's connected to the gear box when you put the car van truck into reverse it hits a switch and turns reverse lights on might just be the wire has come off or the switch is ...
Question about 2001 Sentra
...reverse lights dont work at all. I have checked the bulbs and they are functioning well... sounds like you have a bad ground wire or the wire going to the sides is broken. you may have to check the ...
Question about 2012 Quest S Passenger Minivan 3.5L V6 CVT Automatic
...reverse light wire in the dash? I am installing a radio with back up camera, and I need to find the back up wire below the dash, to add it as a trigger for radio. There may not be a wire in the dash, ...
Question about 2009 Murano
reverse light and backing camera is not working. Might it be a fuse folt?? where could I find it? check light bulbs are ok in reverse lights. Check wiring to reverse lights - see if they put a fuse at
Question about 2009 Murano
...and 5th gear but I cannot reverse. If the reversing lamp has a short on it, it will draw too much power when you enter reverse and the ignition will stop working. Or you have a broken wire,
Question about 2009 Murano
...Nissan Navara, from lights to live wire Older vehicles used a reverse switch on the end of the gearbox to ground the reversing lamps and 12volt feed from the lighting circuit with a 5Amp fuse in
Usually answered in minutes!
1,587 Questions
1,450 Questions
1,309 Questions
1,122 Questions
1,306 Questions