Questions & Answers for: AO Smith reverse wire

wire this motor for reverse rotation First, take the plate where the wires connect to the motor off, and the solution is normally found in the dust cap for the wiring. If not there, go to the AO Smith

...turning impeller. If the impeller has a bolt or screw in the middle remove that first. It should be reverse thread so make sure you don't turn the wrong way and break or strip. If there is no screw, ...

...to you the process on the motor nameplate in the bottom right corner. If you are still unable to reverse it, please reply with a comment that includes the motor serial number and I will go to ...

...wire as far as rotation direction. To change rotation, if the motor allows it, you reverse the start winding leads as directed on your nameplate. If this answer does not fix your problem, please ...

I want to reverse rotation on my A.O. Smith 120/230 volt single phase 1.5 HP motor. Catalog number B762 I believe all you have to do is swap your two hot wires,that works for 3-phase but not sure on ...

...Check to see if the impeller has a screw in the center. If so remove this first. It will be reverse thread. The impeller should spin off counter clockwise. If the impeller is very tight, be ...

...wire coming from motor itself and where they go.....wiring diagram on side only tells leg 1 and leg two and so on, but the wires coming from the motor are not attached to those leads that are marked ...

...reverse the 5 and the 8 wire....on some you will reverse the red and the black.. on others there will be a different combo.... on three phase motors you can reverse any of the incoming leads to ...

need to know what wire goes to were..on a smith & jones modle 67841 compresser motor..p1 p2 t2 t3 t4 t5 t8..to what wire black white green there is a green black and white wire..on my ...