mitac mio 168 won't turn on My mitac mio 168 won't turn on, even if its plugged into the mains. I have tried resetting it but this hasn't helped. Any ideas please ITS THE BATTERY MANY ON EBAY :)
...purchased second hand and it worked fine for the first hou , i had switched it off on the back and reset it and the screen lit up but no sign of an operating system, just a blank but lit screen. Can ...
...digiwalker Mio, which also was freezing up. The only way to sort it is a HARD RESET. The problem in my case appears to be due to the start up program initiating GPS/Tom Tom at the same time. good ...
...me jump though in sequence and then goes back to the beginning of the Align Screen prompt. I've Reset, Hard Reset, Even removed the battery. Still does it. Help????? The touch panel on the LCD ...
...tom keeps freezing I reset my pda to default and now it keeps freezing when I try use the tom tom facility You need to reinstall tom tom. You should also make a backup using the backup manager and ...
...its started up locked and the screen frozen cant open anything up I suppose you have tried a soft reset using the button in the small hole on the LH side & a hard reset using the rear on/off slide ...
...my pda and i took the memory card out when it was on. The screen sort of flashed and went white, I reset it but all that happens now is when its turned on its white with pale blue sides, when it ...
...put my mio P560 in bootloader mode. They only talking about the predecessor Mio P550 (down arrow + reset..that doesn't work on the P560...) Please Help!!! up arrow + power_on until MIO ...
i forgot my password and i cant unlock mio digiwalker p550 You can get the Master Reset Code from the service provider and reset it.
no gps signal on my mio digiwalker 168 Please try and reset the unit , check for fault in the settings . You can also remove the power and try a long reset and if after the boot there is no detection ...
Usually answered in minutes!
62 Questions
16 Questions
2 Questions
7 Questions
2 Questions
