Questions & Answers for: Dodge Stratus reset purge

...dodge stratus wont start drove to friends house shut off 10 min later tried to start and the only thing i get is crank dont hear fuel pump purge and no spark i am lost what do i do tried to reset it

Purge flow valve/ pump system [po441] I see that the code[po441] is a great problem. My check engine light came on. Took it in. Maybe the valve,or the pump. What is the odds that it's the pump? ...

...purge I have sometimes had to drive Chrysler/Dodge vehicles for 70 miles or more before the monitors, or "flags" will reset, and one time a Grand Cherokee took 90 miles to reset the monitors in the ...

How do I fix p0441. A code P0441 could mean one or more of the following has happened: * Bad vacuum switch * Broken or damaged EVAP line or canister * Open in PCM purge command circuit * Open or short

Where is the purge solenoid on an 01 Dodge Stratus 3.0L V6? On top of the fuel tank, it plugs into the tank in a groment and has a vacume line on it and a three wire connector with a weather tight ...

2005 dodge stratus troubleshooting code P0441 This indicates that a part of the EVAP control system is no longer fuctioning correctly. The EVAP system consists of many parts, including (but not ...

po441 on dodge stratus Evap Emissions Problem. Specifically Purge Flow. Check to make sure your gas cap is on tight. Disconnect negative terminal on battery, drive up to 50 miles, if code comes back. ...

what parts do I need for purge flow fault on dodge stratus 2003 If this question is with regards to a fault code of P0441, the following applies.

Basically this means that there is a problem in

where is the purge valve located on a 2004 dodge stratus what are you trying to purge? Should be on a front near injectors it is green.

I have a 2002 dodge status how do fix p1400 p0446 p0441 codes code p0446 refers to evaporative emission (EVAP) system--vent control--circuit malfunction===causes wiring--EVAP canister purge valve--ECM