...Mitsubishi - no change i.e., no picture no sound. Disconncedted, reset no help...What else beside a bad lamp would cause a red lamp status? Haven't been able to find a qualified technican in the San ...
...I think it's just a lemon. Have you reset the TV? Theres a small hole [use a paper clip] to the left of the front panel buttons push in with clip and it will blink and when it stops turn on as ...
...back out and put back in After replacing the lamp cartridge, when you power on the TV, the message "Did you change the lamp? Press ENTER for Yes, press CANCEL for No"will appear, press ENTER to
...Mitsubishi DLP WD-62525. I turned on the TV the other day and it said that the lamp needed to be replaced. Ok no big deal. I ordered a bulb online. It was NOT the assembly. I simply pulled the old ...
Question about WD-62525 62" Rear Projection HDTV
...on your skin) put all the screws and door back on (will not operate without the door) plug it in wait the 90 seconds for mitsubishi to reset then your done.. here is your lamp part number ...
...Mitsubishi WD-62525 without any issues...except the yellow light remains on. Through research I learned I needed to check filter and lamp doors to be sure they are closed correctly...but we get a ...
...Mitsubishi Tv green blinking light and TV will not come on You need a new projector bulb. Google up your model and buy the best warranteed one you cAN FIND. Buy a "caged assembly" and not just a bare ...
reset. I also cleaned the vent/filter thing on the side of the tv. I even tried (semi) unplugging all of the other devices on the back of the tv. I'm at a loss of what to do next expect haul it out to
Question about WD-52327 52" Rear Projection HDTV-Ready Television
...TV that stopped if the lamp is good If the lamp is new and good to go then you may have to reset the lamp replacement counter in your setting menu. When that is set back to zero you wont have a ...
Question about WD65737 65" DLP TV
...Mitsubishi DLP TV. I changed out the DMD formatter Board and DLP Chip Yesterday and now the Lamp will not come on. It worked fine until I changed the Board because it had Vertic Put a brand New Lamp ...
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions