Question about VPL-HS51A / VPL-HS60 Multimedia Projector
reset the lamp timer: 1) With the projector plugged in and turned off, press the 'ON/STANDBY' button to put the projector in 'STANDBY' mode. NOTE: You have to press the button on the projector itself,
Question about LMP-H130 Projector Lamp Projector Lamp for VPL-HS5
reset the lamp timer? Thanks Hello, Set the projector in standby mode. Press the following buttons on remote control in following order for less then five seconds each... RESET, <=== , ===>, ENTERLamp
Reset Timer Lamp Sony VPL-HS60 projector how Do I reset timer of Lamp on My SOny VPL-HS60 Projector? Please Help me. I need to reset my VPL-ES2. I looked at the lamp and it is not burned out. I only ...
reset lamp hours on a vpl px21, just replaced lamp and it is still telling me to replace lamp, unit works fine. Hi! Here is the manual in PDF, on page 33 you can see how to reset the lamp hours. http:
Reset Lamp Hours How do I reset the lamp timer on the SONY VPLCX80 projector? The manual says to press the reset button but when I do it says "NOT APPLICABLE!" hi have vpl-es3 i changed the lamp but i
reset lamp counter in Sony-VPL-ES3 Hi, To reset lamp timer in Sony VPL-ES3, Press following keys on the remote control in following order for less than 5 seconds each, RESET, <<, >>, ENTER
Question about BRAVIA VPL-AW15 LCD Projector
...you reset the lamp timer for a sony Bravia vpl aw15 Go to link below on page 55 through 57 tells you how to replace lamp and reset timer. ...
...and turns Off. any body please help how to reset the lamp timer See http://www.avlamps.eu/projector-lamp-sony-vpl-cs6-_d9953.html for instruction how to reset the timer this page can not be ...
...RESET LAMP Videoprojecteur SONY VPL EX3 procedure ? Hi, You can reset lamp timer of VPL-EX3 by following procedure. Connect power cord in wall socket, standby indicator will lit red. Press following ...
Question about Replacement Lamp for VPL PX21, VPL PX31, VPL PX32 and VPL VW11HT
...reset lamp hours on sony vpl px31 1,Connect the power cord 2,The On/Standy light is red. 3,Press the following keys on the Remote Commander or on the projector in the following order for less than 5 ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions